IS 737 : 2024
WROUGHT ALUMINIUM AND ALUMINIUM ALLOY SHEET AND STRIP FOR GENERAL ENGINEERING PURPOSES SPECIFICATION (Fifth Revision) Amendment - 1
Current edition: 2024
BIS department: MTD
What this standard covers
This standard covers the requirements for wrought aluminium and aluminium alloy sheet and strip for general engineering purposes.
Scope, quoted from IS 737 : 2008 — the 2008 edition in the public archive, not the current IS 737 : 2024. Read the full standard
The BIS registry lists the current edition as IS 737 : 2024. The publicly archived copy quoted here is the 2008 edition, so wording and requirements may have changed since. Check the official BIS listing for what is in force.
Requirements and tests, as the standard names them
- 10.2 Sheet and Strip of Heat-Treatable Aluminium
Sub-clause names as printed under the heading “SELECTION OF TEST SAMPLES” in IS 737 : 2008 (the 2008 archived edition; BIS lists 2024 as current). Values and limits are deliberately not reproduced here — read them in the standard itself.
How the standard is organised
- 4 SUPPLY OF MATERIAL
- 5 FREEDOM FROM DEFECTS
- 6 CHEMICAL COMPOSITION
- 7 MECHANICAL PROPERTIES
- 8 CONDITION
- 9 DIMENSIONS AND TOLERANCES
- 10 SELECTION OF TEST SAMPLES
- 11 RE-TESTS
Test methods it refers to
- IS 504
Edition history (per the BIS registry)
- IS 737 : 2024 — current edition
Where this standard is used on NirmanDost
Materials market
Also cited in the Materials Market rate library and SKU sheets.
Pick up from here
Notes
- Status and titles come from the official BIS published/withdrawn standards registry (standards.bis.gov.in exports, July 2026 snapshot). Editions change — verify on the BIS portal before contractual use.
- The standard text is copyright BIS. NirmanDost shows registry metadata and links to the official source only — it never rehosts the document.
- Generated 2026-07-27.